A gilt brass mounted black japanned quarter-chiming table clock Unsigned, circa 1770 and later The four pillar triple fusee movement with anchor escapement regulated by lenticular bob pendulum, chiming the quarters on a graduated nest of eight-bells and sounding the hours on a further larger bell, the backplate engraved with rococo scrolls around a pagoda, with a 7 inch brass break-arch dial with matted centre within applied silvered Roman numeral chapter ring, with pierced blued steel hands and rococo scroll cast spandrels to angles beneath subsidiary Strike/Silent selection dial flanked by conforming mounts to arch, in a bell-top case with hinged brass carrying handle, brass mouldings and ball finials to the gilt chinoiserie decorated ebonised superstructure over cavetto top mouldings and brass fillet inset break-arch glazed front door incorporating scroll cast brass upper quadrant frets and decorated with further chinoiseries infill to the frame, the sides with conforming decoration and with circular over concave-topped brass fishscale sound frets, the rear with break-arch glazed rectangular door set within the frame of the case, on cavetto moulded skirt base with cast brass ogee bracket feet, (movement originally two-train hour striking only), 47cm (18.25ins) high excluding handle. The movement of the current lot was originally made as a two-train hour striking clock but has been cleverly re-worked into a three-train quarter chiming clock with. This work appears to have been executed relatively early in the clocks life (perhaps circa 1830) and it is also most likely that the gilt japanned decoration to the case was added at that time.